Ver. 1, Rev. 1 QWALL – 5.1 (1 Back Panel) SHOWER ACRYLIC WALL INSTALLATION INSTRUCTIONS IMPORTANT DreamLineTM reserves the right to alter, modify o
Ver. 1, Rev. 1 10 10. Take exact measurements of the fixture on the wall: • from the 1” (one inch) line in the corner of the shower to the fixture:
Ver. 1, Rev. 1 11 12. Drill the holes for the fixtures in the Side panel (01) using the proper diameter saw bit or a handheld jig saw. See Fig. 15 f
Ver. 1, Rev. 1 12 Fig. 17 ATTENTION: 14. Apply the sealant to the entire surface of the reverse side of the Back panel
Ver. 1, Rev. 1 13 15. Attach the Back Panel (09) to the center of the back wall with the equal distance between two lines. See Fig. 19 for details.
Ver. 1, Rev. 1 14 17. Apply the sealant to the entire surface of the reverse side of the Side panel (01). Also, apply the sealant around the drilled h
Ver. 1, Rev. 1 15 19. Apply sealant to the entire surface of the reverse side of the other Side panel (01). See Fig. 21 for details. 20. Slide the
Ver. 1, Rev. 1 16 ATTENTION; Prior to the next step, please be sure the part of the wall for installation of the Decorative edge molding (03) is clea
Ver. 1, Rev. 1 17Glass Shelves Installation Instruction 24. Determine the desired height for the Glass shelves (05) and mark the locations on the wa
Ver. 1, Rev. 1 18 26. Mount the Shelf brackets (04) to the wall using the Countersunk screws ST4.2×30 (07). NOTE: the padded set screw of the Glass b
Ver. 1, Rev. 1 19 Product maintenance To insure long lasting life for your acrylic back walls, wipe them off after each use with a soft cloth. To
Ver. 1, Rev. 1 2 Preparation 1. After opening all boxes and packages, read this introduction carefully. Check that all of the needed parts are inc
Ver. 1, Rev. 1 20 TEL: 866-731-8378 – 215-957-1411 FAX: 866-227-9245 – 215-893-1780 WWW.BATHAUTHORITY.COM For mor
Ver. 1, Rev. 1 3Detailed Diagram of Acrylic Shower Wall Components 56784219334" - 38"30" - 34" Packing List 01 Side panel 2pc
Ver. 1, Rev. 1 4Preparation for Installation of Back Panel 1. Place a mark on the walls at a distance of 1” (one inch) from the corner and draw a p
Ver. 1, Rev. 1 5 3. The Back Panel (09) has 3-1/8” flange on both sides and has to be cut equally from both sides if necessary. See Fig. 3 for det
Ver. 1, Rev. 1 6 5. Mark the measurement “W” on the Back Panel (09) and draw straight lines from top to bottom. NOTE: The Back Panel has to be trim
Ver. 1, Rev. 1 7 Fig. 7 Preparation for Installation of Side Panels ATTENTION: See Fig. 8 for details.
Ver. 1, Rev. 1 8 7. Measure the side walls of the shower from the 1” (one inch) line in the corner (from Step. 1) to the distance where you want Sid
Ver. 1, Rev. 1 9 9. Place the Side panel (01) on a flat piece of plywood or particle board. Use a sharp industrial knife and a T-square to score alon
Comments to this Manuals