DreamLine SHBW-1440742-01 Installation Guide

Ver. 1, Rev. 1 QWALL – 4 ACRYLIC SHOWER WALL INSTALLATION INSTRUCTIONS IMPORTANT DreamLineTM reserves the right to alter, modify or redesign produc

Ver. 1, Rev. 1 10 Fig. 13 10. Apply the sealant to the entire surface of the reverse side of the Side panel (01). Also, ap

Ver. 1, Rev. 1 11 11. Slide the narrow edge of the Side panel (01) behind the Corner cover (02). Align trimmed edge of the Side panel (from Step. 4) w

Ver. 1, Rev. 1 12 14. Once Side panels (01) aligned, fasten tight the Corner cover (02) to secure the Side panels. Cover the screw holes with the Dec

Ver. 1, Rev. 1 13 16. Apply caulk along the top edge of the Side panels (01) and along the connection of the bottom edges of the Side panels with the

Ver. 1, Rev. 1 14 18. Mark the location for the Shelf brackets (04) according to the measurements in Fig. 20 and Fig. 21.1. Drill the holes using Ø5/1

Ver. 1, Rev. 1 15 Fig. 23 Product maintenance To insure long lasting life for your acrylic back walls, wipe them off afte

Ver. 1, Rev. 1 16 TEL: 866-731-8378 – 215-957-1411 FAX: 866-227-9245 – 215-893-1780 WWW.BATHAUTHORITY.COM For mor

Ver. 1, Rev. 1 2Preparation 1. After opening all boxes and packages, read this introduction carefully. Check that all of the needed parts are inclu

Ver. 1, Rev. 1 3Detailed Diagram of Acrylic Shower Wall Components 56784213 Packing List 01 Side panel 2pcs 05 Glass shelf 2pcs 02 Corner cover

Ver. 1, Rev. 1 4Preparation for Installation of Side Panel ATTENTION: See Fig. 1 for details. Fig. 1 1. Place a mark on the

Ver. 1, Rev. 1 5 2. Measure the walls of the shower from the 1” (one inch) line in the corner (from Step. 1) to the points where you want Side panels

Ver. 1, Rev. 1 6 4. Place the Side panel (01) on a flat piece of plywood or particle board. Use a sharp industrial knife and a T-square to score alon

Ver. 1, Rev. 1 7 5. Take exact measurements of the fixture on the wall: • from the 1” (one inch) line in the corner of the shower to the fixture:

Ver. 1, Rev. 1 8 7. Drill the holes for the fixtures in the Side panel (01) using the proper diameter saw bit or a handheld jig saw. See Fig. 9 for

Ver. 1, Rev. 1 9 Fig. 11 9. Mount the Corner cover (02) to the corner of the shower using the Countersunk screws ST4.2×3