DreamLine SHDR-20457210-04 Installation Guide

UNIDOOR SHOWER DOOR INSTALLATION INSTRUCTIONS IMPORTANT DreamLineTM reserves the right to alter, modify or redesign products at any time without

“UNIDOOR” Rev.3 Ver.1 04/2013 10 12. After final adjustments of the Stationary glass (11) drill the holes in the Glass profile (10) through pred

“UNIDOOR” Rev.3 Ver.1 04/2013 11Support bar installation 13. Locate the Support bar (12). Adjust the bar to a proper position on the glass and t

“UNIDOOR” Rev.3 Ver.1 04/2013 12Glass shelves installation 15. Mark the Glass shelf (12) position on the wall. According to the measurements in

“UNIDOOR” Rev.3 Ver.1 04/2013 13 16. Apply the sealant along the connection of the Stationary glass and the Shower base or the threshold. See Fi

DREAMLINE™EXCLUSIVELIMITEDWARRANTYASOFMAY6,2013Thiswarrantyextendsonlytotheoriginalowner/end‐userforhouseholduseonlyandisnottr

TEL: 866-731-2244 FAX: 866-227-1533 WWW.BATHAUTHORITY.COM For more information on DreamLineTM Shower Doors please visit www.Bath

“UNIDOOR” Rev.3 Ver.1 04/2013 2 Preparation 1. After opening all boxes and packages, read this introduction carefully. Check that all of the

“UNIDOOR” Rev.3 Ver.1 04/2013 3Detailed Diagrams of Shower Door Components Diagram A Diagram B

“UNIDOOR” Rev.3 Ver.1 04/2013 4Shower Door Installation 1. Attach the Hinges (05) to the Glass door (01). See Fig. 1 for details.

“UNIDOOR” Rev.3 Ver.1 04/2013 5 3. Mark the drill holes for both hinges on the wall. Set the door aside, drill the holes in the wall using Ø 5/1

“UNIDOOR” Rev.3 Ver.1 04/2013 6 5. Mount the Handle (02) to the Glass door (01). See Fig. 5.1 for details. ATTENTION; Prior to the next step

“UNIDOOR” Rev.3 Ver.1 04/2013 7NOTE: If your door is more than 30” in width, you will need to add Stationary glass panel (11): a) For installati

“UNIDOOR” Rev.3 Ver.1 04/2013 8Stationary Glass Installation 7. Apply clear silicone along the inner channel of the Glass profile (10) and push

“UNIDOOR” Rev.3 Ver.1 04/2013 9 10. Draw a line along the inner edge of the Wall profile (09) on the wall. Detach the Wall profile from the Stat