ELEGANCE SHOWER DOOR INSTALLATION INSTRUCTIONS IMPORTANT DreamLineTM reserves the right to alter, modify or redesign products at any time without p
“ELEGANCE” Rev.2 Ver.2 05/2013 10 ATTENTION: Steps 11-16 Follow these steps if the width of your door is less than 37¾” and you are installi
“ELEGANCE” Rev.2 Ver.2 05/2013 11 12. Use a level to ensure that the Glass door (03) and the Wall profile (05) is absolutely vertical. Draw a li
“ELEGANCE” Rev.2 Ver.2 05/2013 12 14. Adjust the width of the Glass door (03) by pulling out the Glass profiles (2) and (4) if it necessary for
“ELEGANCE” Rev.2 Ver.2 05/2013 13 16. Apply silicone sealant between the tray or threshold and the pivot bracket. Also, apply silicone between t
“ELEGANCE” Rev.2 Ver.2 05/2013 14Stationary Glass Installation 17. Apply clear silicone along the inner chanel of the Glass profile (04) and pu
“ELEGANCE” Rev.2 Ver.2 05/2013 15 19. Use a level to ensure that the Glass door (03) and the Wall profile (05) is absolutely vertical and the Gl
“ELEGANCE” Rev.2 Ver.2 05/2013 16 21. Adjust the width of the opening section of the Glass door (03) by loosen the holding screws on the Pivot a
“ELEGANCE” Rev.2 Ver.2 05/2013 17Glass shelves installation 23. Mark the Glass shelf (31) position on the wall. According to the measurements i
“ELEGANCE” Rev.2 Ver.2 05/2013 18 24. Apply silicone sealant between the tray or threshold, the stationary glass and the accessory. Also, apply
“ELEGANCE” Rev.2 Ver.2 05/2013 19 Maintenance To insure long lasting life for your acrylic back walls, wipe them off after each use with a sof
“ELEGANCE” Rev.2 Ver.2 05/2013 2 Preparation 1. After opening all boxes and packages, read this introduction carefully. Check that all of th
DREAMLINE™EXCLUSIVELIMITEDWARRANTYASOFMAY6,2013Thiswarrantyextendsonlytotheoriginalowner/end‐userforhouseholduseonlyandisnottr
TEL: 866-731-2244 FAX: 866-227-1533 WWW.BATHAUTHORITY.COM For more information on DreamLineTM Shower Doors please visit www.BathAu
“ELEGANCE” Rev.2 Ver.2 05/2013 3Detailed Diagrams of Shower Door Components Diagram A Diagram B 12
“ELEGANCE” Rev.2 Ver.2 05/2013 4Self Closing Pivot Assembly Parts List A Flat head bolt M4×8 1pc G Bolt M12×10 1pc B Pivot bracket 1p
“ELEGANCE” Rev.2 Ver.2 05/2013 5Shower Door Installation 1. Place the Wall profile for glass door (01) on the shower base or the threshold v
“ELEGANCE” Rev.2 Ver.2 05/2013 6 3. Run a silicone bead along the holes on the wall. Attach the Wall profile for glass door (01) and Pivot reta
“ELEGANCE” Rev.2 Ver.2 05/2013 7 5. Slide the Glass profile for glass door (02) with Pivot assemblies (07) into the groove of the Wall profile
“ELEGANCE” Rev.2 Ver.2 05/2013 8 7. Mount the Handle (06) onto the Glass door (03). See Fig. 7 for details. Fig. 7 8.
“ELEGANCE” Rev.2 Ver.2 05/2013 9 9. Close the hole in the bottom Pivot retainer (08) with Flat head socket bolt M6×12 (18) or you can attach th
Comments to this Manuals